Medlin Drone single-axis "Timing Belt" FPV gimbal.  This kit comes preassembled and configured!

This gimbal can be controlled dynamically via  as well as various  or flown fixed-angle while simply controlled on your transmitter via a dial/slider to adjust camera angle mid-flight.

Advantages compared to the include stiffness, perfectly consistent ratio, large range of motion, and aesthetic/professional appearance.  Now featuring a Heavy Duty Universal Mount (increased durability and stiffness) for frames with props larger than 3", if you want the alternate Standard/Heavy Duty mount, specify it in the shopping cart 'Notes' section. 

If there is not a kit for your frame available, you can  for almost any frame.

Works with Analog, DJI O3/O2, HDZero, Walksnail Avatar, etc. FPV systems, may require depending on your setup.

Please Note: FPV camera extension cable is not included, cables for DJI / and  are sold separately.  To power the servo you will need a .

Kit Includes:

-3D Printed Gimbal Design (Includes Pulleys and Strut) 

-1x Digital Metal Gear High Quality Servo

-1x Fiberglass Reinforced Timing Belt

-2x Main Bearings - Sealed Steel Ball Bearings

-2x Strut Bearings - Sealed Steel Ball Bearings

-1x M3 Axle 

-1x Stainless Steel M3 Hardware

-1x Servo Extension Cable

-2x Spare Bearing Spacers 

-1x Wire Shielding 

-2x Shrink Tubing 

----

Weight: 95 grams (it's worth the weight) 

Please allow lead time, gimbals are built on an as-needed basis to avoid waste and is first-come first-serve. 

Required:

-Soldering tools

-Flight controller running Betalight, iNav, or another Cleanflight variant, with available LED pin or unused motor output pin and available 5v source.  However, if using TBS Crossfire or another receiver with ability to output an individual PWM signal on a spare output pad it can be used instead of the flight controller to control gimbal.